Finally got off my ***
#1
Supreme Member
Thread Starter
Join Date: Jan 2004
Location: Western Ky
Posts: 1,206
Likes: 0
Received 3 Likes
on
3 Posts
Car: Z/28..39 Plymouth truck in progress
Engine: S/B
Transmission: Manual
Finally got off my ***
After thinking about this for the last 20yrs I decided to start piecing the system together........still have some parts coming and some to buy yet
#3
Supreme Member
iTrader: (14)
Join Date: Aug 2006
Location: Central NJ
Posts: 12,652
Likes: 0
Received 46 Likes
on
44 Posts
Car: 86 Trans Am, 92 Firebird
Engine: 408 sbc, 3.1L of raw power
Transmission: TKO600, T5
Axle/Gears: Moser 9", 3:70 trutac, 3:23 torsion
Re: Finally got off my ***
hmmm, i like where this is going
#7
Supreme Member
Thread Starter
Join Date: Jan 2004
Location: Western Ky
Posts: 1,206
Likes: 0
Received 3 Likes
on
3 Posts
Car: Z/28..39 Plymouth truck in progress
Engine: S/B
Transmission: Manual
Re: Finally got off my ***
lol thanks man......I had been thinking about doing a stand alone NOS system since I put the big blower on back in 90 but no one made a injection plate for the B&M.....now that they have the under carb plates all I had to do was piece the system together.....ran across the fuel cell and pump used a couple of weeks ago and decided what the heck, now is as good a time as any to blow it up
Trending Topics
#9
Supreme Member
Thread Starter
Join Date: Jan 2004
Location: Western Ky
Posts: 1,206
Likes: 0
Received 3 Likes
on
3 Posts
Car: Z/28..39 Plymouth truck in progress
Engine: S/B
Transmission: Manual
Re: Finally got off my ***
Not tubbed but blown.....lol more super street from back in the day for us older guys , the blower hole on the hood was getting a little ragged after two decades, so I did that design on it last year to clean it up.
Last edited by flrtin1; 04-13-2010 at 02:39 PM.
Thread
Thread Starter
Forum
Replies
Last Post