The Project Begins.
#1
Junior Member
Thread Starter
The Project Begins.
Hello everyone, this post is gonna be me doing my best to document my build. For a little backstory, my car is a 1984 Firebird Trans Am, it has been in my family for 3 generations at this point, my grandma bought it used from a state secretary. then my dad drove it around and after he passed. before it was mine my uncle drove it and he wasn't the best of people to it, the old girl has seen many miles and a lot of hacked up wiring jobs, but anyway my goal with this build is to make it a fun yet streetable daily driver. I am only 18 so bear with me if it takes me time to get things done. as for this rambling on my part its over I'll cut to my build ideas.
I have a 4.8 LS motor complete with the brain box, unfortunately I was not able to get the wiring harness. my idea for this build is to manual swap it as well as upgrade the 4.8 to a 5.3. I will have pictures of the car itself later.
as for right now, I have to get back to studying
I have a 4.8 LS motor complete with the brain box, unfortunately I was not able to get the wiring harness. my idea for this build is to manual swap it as well as upgrade the 4.8 to a 5.3. I will have pictures of the car itself later.
as for right now, I have to get back to studying
The following 2 users liked this post by TheNight:
91banditt2 (06-06-2023), zman1969 (06-02-2023)
#3
Junior Member
Thread Starter
Re: The Project Begins.
Here are a few pictures of the motor.
I paid $500 for it, maybe a little less pricey maybe not. I am not entirely sure
Brain box
I paid $500 for it, maybe a little less pricey maybe not. I am not entirely sure
Brain box
The following users liked this post:
zman1969 (06-02-2023)
#5
Supreme Member
Join Date: May 2015
Location: Florida
Posts: 1,712
Received 241 Likes
on
186 Posts
Car: 1991 Z28
Engine: 305 TPI
Transmission: 700R4
Axle/Gears: 3:42 Auburn
Re: The Project Begins.
Welcome. I have the 4.8 in my Silverado DD. I always thought it would be a good motor swap. it's got some get up and go in my truck. You could probably get a harness from a chevy truck from a scrapyard and adopt it into the TA. Looks like you need a TB also.
#6
Supreme Member
iTrader: (1)
Join Date: Dec 2000
Location: Cincinnati,Ohio
Posts: 2,341
Received 151 Likes
on
111 Posts
Car: 1991 BandittII Firebird
Engine: 5.7 HSR
Transmission: 700R4
Axle/Gears: 3.27 9 bolt
Re: The Project Begins.
Your in the right spot as there's a great deal of knowledgeable enthusiasts here, If you're going to store that outside get any and all opening sealed up to keep as much moisture out as possible.
Thread
Thread Starter
Forum
Replies
Last Post