1991 Z-28
#1
Member
Thread Starter
iTrader: (6)
Join Date: Jan 2003
Location: indiana
Posts: 255
Likes: 0
Received 1 Like
on
1 Post
Car: 91 Z-28
Engine: 420 sbc
Transmission: T56
Axle/Gears: 12 bolt/4.10 gears
1991 Z-28
Finally got my camaro finished and painted. Thought I would post a pic and see what you guys think. It turned out nice. This is the car that I bought from cam-aro 5 years ago.
#4
Member
Thread Starter
iTrader: (6)
Join Date: Jan 2003
Location: indiana
Posts: 255
Likes: 0
Received 1 Like
on
1 Post
Car: 91 Z-28
Engine: 420 sbc
Transmission: T56
Axle/Gears: 12 bolt/4.10 gears
Re: 1991 Z-28
The back story is I bought the car in 2008. Overall it was in really good shape. It already had a miniram, dart heads, a cam, t56 trans, and a 12 bolt installed. It ran ok but not great. The rear end had a spool which I hated and will never put in anything I own again. There were a few things the previous owner had done that I didnt care for so I decided to redo the whole drivetrain. I built a 420 inch motor with afr heads and a ported miniram. I yanked the spool out of the rear and put in a wavetrac. I also rebuilt the t56 and used a QuickTime bell housing and spec clutch. It dyno'd 475 rwhp and runs 11.20's at 121-123 as it sits in the picture.
#7
Member
Thread Starter
iTrader: (6)
Join Date: Jan 2003
Location: indiana
Posts: 255
Likes: 0
Received 1 Like
on
1 Post
Car: 91 Z-28
Engine: 420 sbc
Transmission: T56
Axle/Gears: 12 bolt/4.10 gears
Re: 1991 Z-28
It's a TPIS ZZ-X. peaks at 6200 and carries to 7000. I shift at 6800. I think it'll go 10.9's with a dead hook.
Thread
Thread Starter
Forum
Replies
Last Post