Trying to get this speedo done
03-31-2013, 07:22 PM
#1
Supreme Member
Thread Starter
iTrader: (1)
Join Date: Feb 2003
Location: check under the car
Posts: 1,143
Likes: 0
Received 4 Likes
on
3 Posts
Car: White 25th Anniversary RS
Engine: lt1
Transmission: t56
Axle/Gears: 4:10
Trying to get this speedo done
I have a wierd setup.
my real question is.
Does the ls1 t56 vss output the same way the lt1 t56 does?
I have a lt1 but am using a ls1 t56 so the vss might be different.
my pig tail to hook the vss up should be here any day so I can get that soldered on and be ready to test it.
How its hooked up now.
vss feeds to lt1 pcm via purple and yellow wires.
LT1 pcm speedo output feeds to a gray wire that goes to the dash.
I just wanted to verify if this is correct.
my real question is.
Does the ls1 t56 vss output the same way the lt1 t56 does?
I have a lt1 but am using a ls1 t56 so the vss might be different.
my pig tail to hook the vss up should be here any day so I can get that soldered on and be ready to test it.
How its hooked up now.
vss feeds to lt1 pcm via purple and yellow wires.
LT1 pcm speedo output feeds to a gray wire that goes to the dash.
I just wanted to verify if this is correct.
04-06-2013, 05:17 PM
#3
Supreme Member
iTrader: (24)
Join Date: Jun 2005
Location: NC
Posts: 7,899
Likes: 0
Received 90 Likes
on
54 Posts
Car: 92 Firebird
Engine: Supercharged 6.0
Transmission: T56
Axle/Gears: 8.8 3.73
Re: Trying to get this speedo done
It is the same 17ppr to the PCM which converts it to 4,000ppm the speedo can understand
Thread
Thread Starter
Forum
Replies
Last Post
