Lt1 harness.... fusing?
09-27-2006, 07:29 PM
#1
Member
Thread Starter
iTrader: (1)
Join Date: Dec 2002
Location: Poconos, Pa
Posts: 287
Received 0 Likes
on
0 Posts
Car: 1984 Firebird
Engine: LT1
Transmission: T5
Axle/Gears: 3.42's
Lt1 harness.... fusing?
Hey all....
I just swapped in a 93 LT1 in my 84 Firebird, she runs and everything (yay!)
But.. that brings me to the question... exactly where do I want to put fuses?
I had my harness modified by Dana at LT1350.com. He brought out two power wires for me, one for ignition, and the other for switched 12 volts.... I could add the fuses there, but I think it would look extremely tacky. I'd like to tap into the stock Fuse panel, but, from the best that I can tell, I only have one fuse there (10 amp) for my old ECM (Was a 2.8 carb'ed V6). I know I'll have to put one inline for the fuel pump, since the panel was not setup for an electric fuel pump. (But I'll live)
Anyone have any suggestions?
Thanks!
I just swapped in a 93 LT1 in my 84 Firebird, she runs and everything (yay!)
But.. that brings me to the question... exactly where do I want to put fuses?
I had my harness modified by Dana at LT1350.com. He brought out two power wires for me, one for ignition, and the other for switched 12 volts.... I could add the fuses there, but I think it would look extremely tacky. I'd like to tap into the stock Fuse panel, but, from the best that I can tell, I only have one fuse there (10 amp) for my old ECM (Was a 2.8 carb'ed V6). I know I'll have to put one inline for the fuel pump, since the panel was not setup for an electric fuel pump. (But I'll live)
Anyone have any suggestions?
Thanks!
Thread
Thread Starter
Forum
Replies
Last Post
gta892000
Cooling
6
09-16-2015 12:37 AM
