GTA headrest
#2
Supreme Member
iTrader: (5)
Join Date: Nov 2010
Location: Mantua NJ
Posts: 5,827
Received 64 Likes
on
57 Posts
Car: 1 Owner 1986 TA with a WS6 package
Engine: 5.0 EFI
Transmission: THM700R4
Axle/Gears: 277 Posi Speedo
Re: GTA headrest
to remove it from the back of the seat i"m going to say use a metal type ruler and stick it down the back between the metal section of the headreast
and wiggle up and down till the headrest comes out.
and wiggle up and down till the headrest comes out.
#3
Supreme Member
iTrader: (9)
Re: GTA headrest
IIRC, (and this is from memory 20 years back, so proceed with caution)
The actual pad is clipped on. It pulls off the headrest, from there are two screws that hold the plastic cover in place. The two ***** have a screw behind the round rubber covers (they just pull off). Before you stick a ruler in, pull the accordion boot off from the underside of the HR, but be careful, it rips easy. The seatback side is held on by a plate/screws, but you have to slide the HR out of the seatback if you want to remove the boot.
The actual pad is clipped on. It pulls off the headrest, from there are two screws that hold the plastic cover in place. The two ***** have a screw behind the round rubber covers (they just pull off). Before you stick a ruler in, pull the accordion boot off from the underside of the HR, but be careful, it rips easy. The seatback side is held on by a plate/screws, but you have to slide the HR out of the seatback if you want to remove the boot.
Thread
Thread Starter
Forum
Replies
Last Post
1FSTGTA
Third Gen Association of Ontario
13
02-26-2003 09:42 PM