passenger seat to driver seat
#1
Member
Thread Starter
passenger seat to driver seat
91 Z28. I want to replace my driver seat because of a tear. Can you swap the side lever & forward tilt lever/**** from a driver seat to a front passenger seat so you can use it on the driver side?
#2
Supreme Member
iTrader: (7)
Join Date: May 2004
Location: Lexington, SC
Posts: 5,291
Likes: 0
Received 58 Likes
on
52 Posts
Car: 1987 SC/1985 TA
Engine: 350/vortec/fitech
Transmission: T56
Axle/Gears: 3.27 9-bolt
Re: passenger seat to driver seat
one's I've dealt with would not allow swapping sides for the tilt mechanism controls.
best bet may be to swap the foam and good fabric from one seat to the next. passenger seats are usually an excellent option for 'like-new' foam.
best bet may be to swap the foam and good fabric from one seat to the next. passenger seats are usually an excellent option for 'like-new' foam.
#3
Supreme Member
iTrader: (2)
Join Date: Apr 2000
Location: South Windsor, CT
Posts: 1,264
Likes: 0
Received 212 Likes
on
178 Posts
Car: '89 GTA
Engine: ZZ6TPI
Transmission: T56
Axle/Gears: Borg Warner 3.70:1
Re: passenger seat to driver seat
The frames are specific to each side, but the foam and covers can be swapped.
#4
Member
Thread Starter
Re: passenger seat to driver seat
Sounds like a plan. Any trick to getting the foam & cover off with out destroying it?
#5
Member
Re: passenger seat to driver seat
Should come off very easy. When you go to put the back cover on put a plastic bag over foam first be for pulling cover. this will let it slide over easier. then rip plastic and pull out.
#6
Supreme Member
iTrader: (2)
Join Date: Apr 2000
Location: South Windsor, CT
Posts: 1,264
Likes: 0
Received 212 Likes
on
178 Posts
Car: '89 GTA
Engine: ZZ6TPI
Transmission: T56
Axle/Gears: Borg Warner 3.70:1
Re: passenger seat to driver seat
You will also need to cut the hog rings to get it apart and then put it back together with new ones. Get a good pair of hog ring pliers.
Thread
Thread Starter
Forum
Replies
Last Post