padak

iTrader: (10)

Where can I get one of these? I got manual console just like this for my car, I have been searching on here, I found this picture in a thread from 2005, rather than bumping it, I decided to make a new one.

padak

iTrader: (10)

padak

iTrader: (10)

Was this a custom job or do they sell these?

toxik IROC

iTrader: (12)

You could use something like this http://www.nitrousoutlet.com/nitrous...automatic.html

Or you can use some plexiglass and dremle out the propor size hole you may need.

Or follow this link... https://www.thirdgen.org/forums/inte...s-4th-gen.html

Enjoy.

zracer92

iTrader: (4)

http://6litereaterdesigns.com/store/...h=165_21_37_56

willexoIX

I have a thread on the fabrication subforum named "another ashtray switch panel". I used a piece of plexiglass and low profile rocker switches to make it and it fits under the stock flip lid. Ill hop on the computer in a little while and post up the link for you.

padak

iTrader: (10)

Awesome, thank you so much. I am using the two stock power window buttons and will put them in this location. Trying to figure up a neat way to wire up two military toggle switches though somewhere else. Once for the fan, and the other, not sure yet.

toxik IROC

iTrader: (12)

if you are looking for switches check out these guys and they will look better than a millitary switch. http://www.otrattw.com/

toxik IROC

iTrader: (12)

http://www.otrattw.com/proddetail.ph...C9B-17T&cat=35