Requesting pics of hood to cowl weatherstrip
#1
Requesting pics of hood to cowl weatherstrip
Looking through my spare parts boxes today I found a new weatherstrip piece I had purchased back in 2008. Needless to say, it's been so long, I can't remember how the old one came off so that I could install this one in its place.
Anyone have slight distance and closeup photos I can use for reference?
Thanks in advance! (1987 Iroc)
Anyone have slight distance and closeup photos I can use for reference?
Thanks in advance! (1987 Iroc)
#4
Supreme Member
iTrader: (3)
Join Date: Jan 2004
Location: Las Vegas
Posts: 2,675
Likes: 0
Received 242 Likes
on
182 Posts
Car: 1987 Formula (original owner)
Engine: 305 TPI
Transmission: T5
Axle/Gears: 9-bolt/3.45
Re: Requesting pics of hood to cowl weatherstrip
The hood has small holes across it, about 1/8" diameter. And the molding has (should have) small plastic pins in it. Line-up the pins to the holes and push 'em in. But make sure the pins and the holes all match-up before pushing them in. If they aren't matching-up, then flip the molding end-to-end.
#5
Re: Requesting pics of hood to cowl weatherstrip
The hood has small holes across it, about 1/8" diameter. And the molding has (should have) small plastic pins in it. Line-up the pins to the holes and push 'em in. But make sure the pins and the holes all match-up before pushing them in. If they aren't matching-up, then flip the molding end-to-end.
For those of you who don't have one, it'll prevent a lot of debris from getting under the hood via the wipers area.
The following users liked this post:
T.L. (11-04-2023)
#8
Senior Member
Re: Requesting pics of hood to cowl weatherstrip
So I removed it & ordered a new one. Still have not installed it.
Thread
Thread Starter
Forum
Replies
Last Post
Nasty_Bird_'90
Auto Detailing and Appearance
1
08-05-2002 11:22 AM