LS swap steam line port.
#1
Senior Member
Thread Starter
LS swap steam line port.
Newb to tig welding, and havent touched a lathe in a few years, but had some time today and made up a fitting to route my steam line to the upper rad hose.
I made a "temporary" fitting well over 5 years ago and it never gave me any issues but it wasn't meant to be permanent and it started to corrode being in contact with 2 dissimilar metals (brass and the galvanized steel).
Not really a big fab job, but it counts!
I made a "temporary" fitting well over 5 years ago and it never gave me any issues but it wasn't meant to be permanent and it started to corrode being in contact with 2 dissimilar metals (brass and the galvanized steel).
Not really a big fab job, but it counts!
The following users liked this post:
TTOP350 (01-15-2020)
#2
Moderator
Join Date: Jul 1999
Location: 51°N 114°W, 3500'
Posts: 17,120
Likes: 0
Received 123 Likes
on
104 Posts
Car: 87 IROC L98
Engine: 588 Alcohol BBC
Transmission: Powerglide
Axle/Gears: Ford 9"/31 spline spool/4.86
Re: LS swap steam line port.
It's nice when you have tooling to fabricate what you need.
Thread
Thread Starter
Forum
Replies
Last Post