[TX] WTB: Taillight Center For 1988 Firebird Formula.
#1
Senior Member
Thread Starter
iTrader: (1)
Join Date: Feb 2011
Location: Round Rock, TX
Posts: 670
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1988 Firbird formula 350
Engine: 5.7L TPI
Transmission: 700R4
Axle/Gears: 3.27 Nine Bolt
WTB: Taillight Center For 1988 Firebird Formula.
I'm looking for a taillight center/filler for a 1988 Firebird Formula in good condition with a silver Firebird logo.
#2
Member
Join Date: Nov 2010
Location: Sylmar, So-Cal
Posts: 325
Likes: 0
Received 0 Likes
on
0 Posts
Car: 89 firebird bone stock for now
Engine: 2.8L V6
Transmission: 700R4
Axle/Gears: B.W 9Bolt 3.27 Posi
Re: WTB: Taillight Center For 1988 Firebird Formula.
If youre still looking for one i have one with a tiny chip in it. inner paint chip. let me know]]
you can just message me.
you can just message me.
#4
Supreme Member
iTrader: (34)
Join Date: Jul 2002
Location: Stamford, New York
Posts: 1,983
Likes: 0
Received 6 Likes
on
3 Posts
Car: 80 SE/TTA;88 T/A GTA;86 T/A
Engine: 4.9L Turbo; LT1; empty
Transmission: TH350; T56; empty
Axle/Gears: 3:23 disk; 4:10 disk ; 3.42 disk
Re: WTB: Taillight Center For 1988 Firebird Formula.
i got a couple too, PM me.
#5
Senior Member
Thread Starter
iTrader: (1)
Join Date: Feb 2011
Location: Round Rock, TX
Posts: 670
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1988 Firbird formula 350
Engine: 5.7L TPI
Transmission: 700R4
Axle/Gears: 3.27 Nine Bolt
Re: WTB: Taillight Center For 1988 Firebird Formula.
After a couple of tries, I finally found a good one. Now I have 2 bad ones with the black backing bubbling off. I'm going to experiment on them to see if I can refinish them somehow. Thanks for the replies.
#6
Supreme Member
iTrader: (34)
Join Date: Jul 2002
Location: Stamford, New York
Posts: 1,983
Likes: 0
Received 6 Likes
on
3 Posts
Car: 80 SE/TTA;88 T/A GTA;86 T/A
Engine: 4.9L Turbo; LT1; empty
Transmission: TH350; T56; empty
Axle/Gears: 3:23 disk; 4:10 disk ; 3.42 disk
Re: WTB: Taillight Center For 1988 Firebird Formula.
A little bit of fine fine grit sand paper and flat black paint should get them up. just be careful because the bird is a sticker on the inside.
Thread
Thread Starter
Forum
Replies
Last Post
theshackle
Tech / General Engine
4
03-05-2017 06:37 PM
TA8487
Engine/Drivetrain/Suspension Wanted
1
08-16-2015 12:21 PM
Mister_Johnny99
Interior Parts Wanted
0
08-14-2015 12:59 PM