What should ls1 injectors ohm?
#1
Member
Thread Starter
iTrader: (8)
Join Date: Mar 2006
Location: TN
Posts: 205
Likes: 0
Received 1 Like
on
1 Post
Car: 92 rs z28 clone
Engine: forged 350
Transmission: 700r4 fully built
Axle/Gears: moser axles eaton posi 3.73 gears
What should ls1 injectors ohm?
I am planning on running ls1 injectors in my new setup and just purchased some used ones and just want to make sure they are ok.
#2
Supreme Member
iTrader: (24)
Join Date: Jun 2005
Location: NC
Posts: 7,899
Likes: 0
Received 90 Likes
on
54 Posts
Car: 92 Firebird
Engine: Supercharged 6.0
Transmission: T56
Axle/Gears: 8.8 3.73
Re: What should ls1 injectors ohm?
Ohm them out and write down each value. A bad injector will be significantly higher or lower than the rest, usually +1ohms or greater
#3
Member
Thread Starter
iTrader: (8)
Join Date: Mar 2006
Location: TN
Posts: 205
Likes: 0
Received 1 Like
on
1 Post
Car: 92 rs z28 clone
Engine: forged 350
Transmission: 700r4 fully built
Axle/Gears: moser axles eaton posi 3.73 gears
Re: What should ls1 injectors ohm?
I did and got 12.7-13.3 what does a new one ohm? my others ohm 14.5 but they are ford 19#
#4
Supreme Member
iTrader: (24)
Join Date: Jun 2005
Location: NC
Posts: 7,899
Likes: 0
Received 90 Likes
on
54 Posts
Car: 92 Firebird
Engine: Supercharged 6.0
Transmission: T56
Axle/Gears: 8.8 3.73
Re: What should ls1 injectors ohm?
Thats well within range. Problem injectors are obvious, as in 15+ ohms for that set. +/- .3 ohms is fine
Thread
Thread Starter
Forum
Replies
Last Post
dbrochard
Engine/Drivetrain/Suspension Parts for Sale
6
09-19-2015 08:13 PM