Update on my VATS problems, Fixed.
#1
Member
Thread Starter
iTrader: (4)
Join Date: Jun 2001
Location: new phila, oh
Posts: 278
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1990 RS
Engine: LS1
Transmission: T56
Axle/Gears: 3.73 9 bolt
Update on my VATS problems, Fixed.
Well I am finally done with school and have a few weeks to mess with the car before I go back. For those who dont remember my LT1 would not start or crank and the security light was on. Well I sat down and started going over the VATS system and found that my VATS relay is not working. I manually made the relay work and it started sright up. Thanks for everyones help.
#2
what wire is the vats? I know it is in the grey connector but what terminal is it in? I have a bypass module from Painless and the instructions are really really bad i can not figure out which wire it is
Thanks
Thanks
#4
Supreme Member
Join Date: May 2002
Location: Chicago, Il
Posts: 1,218
Likes: 0
Received 1 Like
on
1 Post
Car: 1987 Trans Am
Engine: Lt1
Transmission: T56
Originally posted by 84CamroHO
what wire is the vats? I know it is in the grey connector but what terminal is it in? I have a bypass module from Painless and the instructions are really really bad i can not figure out which wire it is
Thanks
what wire is the vats? I know it is in the grey connector but what terminal is it in? I have a bypass module from Painless and the instructions are really really bad i can not figure out which wire it is
Thanks
Thread
Thread Starter
Forum
Replies
Last Post
Street Lethal
Power Adders
634
04-30-2019 12:14 PM