[FL] Looking for six bolt 4l60e tail shaft housing with torque arm mount
#1
Looking for six bolt 4l60e tail shaft housing with torque arm mount
Like a fool, I forgot to grab one from the 02 my local pick and pull had and by the time i got back it was crushed. So, trying to find one. If the bushings/seal are wiped that's even better. Mocking up a Speedo drive setup in my non torque arm tailshaft soni can perfect the measurements for my swap.
#3
Supreme Member
iTrader: (5)
Join Date: Aug 2011
Location: Jackson NJ
Posts: 1,189
Received 160 Likes
on
104 Posts
Car: 1984 T/A
Engine: LQ4
Transmission: T56
Axle/Gears: Ford 8.8 4.10 gears
Re: Looking for six bolt 4l60e tail shaft housing with torque arm mount
If you use the holley/jhooker crossmember you dont need it. has the torque arm mount on the crossmember itself.
#4
Re: Looking for six bolt 4l60e tail shaft housing with torque arm mount
I appreciate the insight. If I can't find one by the time the car is built I'll go that route. The tailshaft housing shouldn't be more than $50, so just trying to avoid unnecessary costs in the build at the moment. But if all else fails, that's a good option.
Thread
Thread Starter
Forum
Replies
Last Post
bryanwood74
Suspension and Chassis
2
03-09-2016 09:34 AM
five7kid
LTX and LSX
32
07-04-2013 07:54 PM