WTB: Used Roller Cam
01-05-2013, 12:24 AM
#1
Supreme Member
Thread Starter
iTrader: (1)
Join Date: Mar 2001
Location: Medford, Oregon
Posts: 3,245
Likes: 0
Received 1 Like
on
1 Post
Car: 1989 Iroc Z L98
WTB: Used Roller Cam
I am looking for a roller cam, I am upgrading the top end of my stock L98 with a set of vortec heads and a carb.
I am hoping for something similar to an LT4 hot cam, something in the 220-230* @.050 range and under .540 lift w/ 1.6 rockers.
PM me if you have something that might work for me
.
I am hoping for something similar to an LT4 hot cam, something in the 220-230* @.050 range and under .540 lift w/ 1.6 rockers.
PM me if you have something that might work for me
. 
01-08-2013, 04:27 PM
#2
Supreme Member
iTrader: (35)
Join Date: Feb 2003
Location: Albuquerque, NM
Posts: 1,229
Likes: 0
Received 3 Likes
on
2 Posts
Car: 1966 El Camino Custom
Engine: 350
Transmission: 200R4
Axle/Gears: 3:73 12 bolt with Brute Strength
Re: WTB: Used Roller Cam
Just a friendly FYI, carb motors prefer a tighter lobe separation angle (LSA) than fuel injected motors. You'll be happier to find one in the 106 to 110 degree range rather than the fuelies 112 to 114 degree range. I went carb on my '85 IROC and originally found a wider separation roller cam. It was pretty soft in the bottom compared to the tighter lobed cam I replaced it with.
02-05-2013, 12:33 PM
#3
Member
iTrader: (5)
Join Date: Sep 2002
Location: Goldsboro, NC
Posts: 155
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1991 Camaro RS
Engine: 350, Edelbrock Pro Flo efi
Transmission: T56
Axle/Gears: 4.10 on a torsen diff
Re: WTB: Used Roller Cam
I'm sure it's smaller than what you're looking for, but how a bout a ZZ4 cam? .474/.510, not sure about the LSA.
Thread
Thread Starter
Forum
Replies
Last Post