When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Installed and aligned then removed. Zero miles on them. These were used for mock up purposes.
The Detroit Speed Caster/Camber Plate Kit is a direct bolt-on kit that allows precise camber and caster adjustments at the strut tower. The kit features Speed-LIGN technology that allows consistent and precise movements without any worry of unwanted movement after the adjustment is made. The camber and caster can be adjusted independent of each other and allows increased adjustment range over stock. The kit uses an aircraft-grade monoball for strut shaft attachment for smooth, precise articulation throughout suspension travel. Note: The Caster/Camber Plate Kit also includes the Detroit Speed, Inc. Strut Mount Retainer Kit. It is a direct bolt-in replacement for the 1987-92 vehicles that will come electroplated with new hardware. They can also be used to replace the strut mount retainers on 1982-86 vehicles by slotting one hole in the strut tower.
Will trade (+/- cash) for: Looking for a 00-02 Camaro, ls1/auto parts car Steering column with tilt, cruise, delay wipers for manual trans 00-02 HVAC controls, wiring, vacuum lines. I also need misc AC parts. Need complete windshield wiper setup from 98-02 Camaro
3rd gen parts: 3rd gen LS swapped CAI (behind drivers headlight) Remote battery mount 86-90 K-member, if it's already notched out for AC that's a plus
Re: SOLD - $450 - Detroit Speed (DSE) Caster Camber Plate Kit 82-92 Camaro/Firebird
I had two sets. One I used for mocking up my build and the other was new in box for another build which I'm no longer building. The shop installed the new set instead of reinstalling the ones we used for mockups. I'm in the process of getting ready to sell the LS1/M6 build (pictured) and I'm selling the set I used for mocking up.
10-03-2021, 07:16 AM
