SLP RUNNERS
#6
Senior Member
Re: SLP RUNNERS
The following 2 users liked this post by no new tires:
georgealtemus (07-04-2020), Irocan88 (08-19-2020)
#7
Re: SLP RUNNERS
630 shipped for either set polished or cast polished has the ninth injector welded shut yes aluminum welded then polished never seen the 1st design w/o cold start from slp
so if u have 9th injector you would need to delete it for the polish set unless you drill grind down the original pattern
slp would use a allen bold on either end then grind them down on the other side it was actuall cast with out the bigger hole
so if u have 9th injector you would need to delete it for the polish set unless you drill grind down the original pattern
slp would use a allen bold on either end then grind them down on the other side it was actuall cast with out the bigger hole
Trending Topics
#11
Supreme Member
Join Date: Oct 2000
Location: Park City, UT
Posts: 1,977
Received 300 Likes
on
206 Posts
Car: '92 Corvette, '89 1/2-a-'Vette
Engine: LT1, L98
Transmission: ZF6, ZF6
Axle/Gears: 3.45, 3.31
Re: SLP RUNNERS
I don't think so. You can buy entire intake manifolds for less -manifolds that make more power than those runners ever will, on any base. $630 for bent tubes is DUMB. I have money, but I"d never spend over ~$150 for any bolt-on, TPI "runners". Which is probably why I have money. $630 has to be one of the poorer BFTB upgrades you can do to a motor, but best of luck to the seller, and here is a bump.
Thread
Thread Starter
Forum
Replies
Last Post
1992 Trans Am
Engine/Drivetrain/Suspension Parts for Sale
3
05-11-2020 08:49 AM