[MI] Parting out Firebird
#1
Junior Member
Thread Starter
Join Date: Nov 2018
Posts: 22
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1990 Firebird Drag car build
Engine: 355 being rebuilt
Axle/Gears: 4.56 LDS
Parting out Firebird
I'm parting out an 3rd gen Firebird that I picked up as a parts car. The car was pieced together previously so the interior colors are grey and tan. It is a T-top car and someone loosely installed a 9 bolt rear under it so I could roll it onto my trailer. Let me know what you are looking for and I can see if I can meet your need.
I've also got a titled 88 Firebird Roller with 8 point roll cage, Spohn Torque Arm with TH 350 Tranny mount, 4.56 posi-traction rear end. I have an 84 Firebird set of front fenders and front bumper cover to go on the car and finish up all the sheet metal. The car has no interior and the wiring has been cut up. I do have a set of black seats that can go with the car and a dash cluster. I was going to make myself a 1/8 mile drag car out of this, but I've got too much on my plate already. $900
I've also got a titled 88 Firebird Roller with 8 point roll cage, Spohn Torque Arm with TH 350 Tranny mount, 4.56 posi-traction rear end. I have an 84 Firebird set of front fenders and front bumper cover to go on the car and finish up all the sheet metal. The car has no interior and the wiring has been cut up. I do have a set of black seats that can go with the car and a dash cluster. I was going to make myself a 1/8 mile drag car out of this, but I've got too much on my plate already. $900
Last edited by DEADWOLF; 09-23-2019 at 08:58 AM.
#2
Junior Member
Thread Starter
Join Date: Nov 2018
Posts: 22
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1990 Firebird Drag car build
Engine: 355 being rebuilt
Axle/Gears: 4.56 LDS
Re: Parting out Firebird
Also have the front bumper solid piece just needs repainted along with headlight buckets.
#4
Junior Member
Thread Starter
Join Date: Nov 2018
Posts: 22
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1990 Firebird Drag car build
Engine: 355 being rebuilt
Axle/Gears: 4.56 LDS
Thread
Thread Starter
Forum
Replies
Last Post