Lakwood 90/10 struts and rear 3 way adjustable shocks Drag race parts
03-05-2018, 07:40 PM
#1
Senior Member
Thread Starter
Join Date: Jan 2005
Location: Port Angeles, Wa
Posts: 783
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1983 Camaro Z28
Engine: 584
Transmission: TSI Glide
Axle/Gears: Quick performance 9 inch
Lakwood 90/10 struts and rear 3 way adjustable shocks Drag race parts
One set of Lakewood 90/10 front struts part number 40510 these are like new. had about 60-70 passes on them. Sat in the garage the rest of the time. 175 plus shipping to you. Save yourself 100 over new.
One set of Competition Engineering 3 way adjustable rear shocks. These have 47 passes on them. 75 plus shipping.
Front moroso sbc trick springs with 1 1/2 coils cut. It sit's right about factory height in my car. 60 plus shipping.
Going to be pulling the car apart this week and finding these new homes.
Also have a set of Moser 31 spline axles setup for 5/8's drive studs out of a moser 9 for 82-92 f body. Axles measure 28 1/2 and 31 7/8 inches. Will need studs and new bearings since these were starting to seep.
200 for the set.
One set of Competition Engineering 3 way adjustable rear shocks. These have 47 passes on them. 75 plus shipping.
Front moroso sbc trick springs with 1 1/2 coils cut. It sit's right about factory height in my car. 60 plus shipping.
Going to be pulling the car apart this week and finding these new homes.
Also have a set of Moser 31 spline axles setup for 5/8's drive studs out of a moser 9 for 82-92 f body. Axles measure 28 1/2 and 31 7/8 inches. Will need studs and new bearings since these were starting to seep.
200 for the set.
Last edited by izcain; 03-05-2018 at 09:13 PM.
Thread
Thread Starter
Forum
Replies
Last Post
scorchmaster
Engine/Drivetrain/Suspension Wanted
0
12-06-2007 08:21 AM
five7kid
Organized Drag Racing and Autocross
6
10-07-2002 02:11 PM