fasteddi

iTrader: (2)

Gauging any interest in the V6 community wanting V6 headers built for a turbo set up. They would be molded off of mine. But would fit 2.8l/3.1/3.4 v6s. Front facing tube headers only, no log set up. Prices vary upon the material, steel vs SS and so on. I recently made a set for a friend. And the process went well so im seeing if anyone else needs some headers.

I would also need to know if its for a RWD block or a FWD block...exc.

There are a few pics below. Older ones. But in these pics the headers were mig welded, the headers I would make would be 100% tig welded. Guaranteed pretty welds.

Just some rough pics below. I can upload better pics if the interest it there. Thanks

Base91

iTrader: (1)

Interest may depend a lot on price. What are you projecting?

fasteddi

iTrader: (2)

Depending on the material and also what flanges they would want, and if they wanted a crossover built... it would cost somewhere around 425-650 bucks.

Wafflestomp

Im interested I dont have a welder so this would help alot with my turbo build

fasteddi

iTrader: (2)

Well let me know if you want a set built up. Of course I have a job so i couldnt make them over night or anything but if i had a week i would have you a set in the mail. Depending on what you want and what your goals are the price can be lower or higher, but i can do those log headers if you want as well. they are much less cost and effort for me, and to be honest they will support 350hp all day long. I ran log headers for 2 years before i finally started building full tube headers.