Converted LT1 heads and intake
#1
Converted LT1 heads and intake
I have a set of LT1 heads and and lt1 intake for sale. I converted these a few years ago and the project they were for fell through. These fit on a standard small block. You need a remote t-stat housing for them and that is about it. They also have new lt4 springs and retainers.
The intake has been fitted for a distributor and the egr ports have been closed off. The fuel rails and 24lb injectors are included along with the fuel lines that went through the fender on a 4th gen. The polylocks are not included.
I would like $500 shipped. There is a sticky on the tpi page all about this conversion. Any questions pm me.
The intake has been fitted for a distributor and the egr ports have been closed off. The fuel rails and 24lb injectors are included along with the fuel lines that went through the fender on a 4th gen. The polylocks are not included.
I would like $500 shipped. There is a sticky on the tpi page all about this conversion. Any questions pm me.
#5
Junior Member
Join Date: Mar 2006
Location: ohio
Posts: 40
Likes: 0
Received 0 Likes
on
0 Posts
Car: 92 camaro z28
Engine: 355 tpi
Transmission: t-5
Axle/Gears: 373
Re: Converted LT1 heads and intake
im really interested if some stuff goes good this week ill get a hold you you again but right now just wondering is there any other work done like port and polish and do you know the specs on the heads also how much better does this setup flow better than a tpi thanks Jermey
Thread
Thread Starter
Forum
Replies
Last Post
LT1Formula
Engine/Drivetrain/Suspension Parts for Sale
20
11-14-2015 12:02 AM