How do you remove the giant plug for the gauges.
02-06-2013, 03:31 PM
#1
Member
Thread Starter
Join Date: Jul 2011
Location: Billings, MT
Posts: 174
Likes: 0
Received 0 Likes
on
0 Posts
Car: 92 Firebird--02 Grand Prix GTP 2Dr
Engine: Poncho 400--3.8 Supercharged
Transmission: T56 6 Speed--4T65EHD
Axle/Gears: Open 10 bolt 3.42--Internal 2.93
How do you remove the giant plug for the gauges.
I need to remove the entire thing so i can clean it up. I'm doing a full 100 percent re wire under the hood, no butt-splices, so I'm buying new terminals to do so. I can't figure out how the hell to pull this thing out.
It's in the firewall behing the strut tower on the driver side circled in the picture.
It's in the firewall behing the strut tower on the driver side circled in the picture.
02-06-2013, 04:07 PM
#2
Re: How do you remove the giant plug for the gauges.
The fuse box connector? There's a screw in the middle and the 2 parts of the harness snap into each other, one is for the engine stuff the other for the headlights, horns and all.
Poke around in the sealant crap, the hex head is in there
Poke around in the sealant crap, the hex head is in there
02-06-2013, 05:30 PM
#3
Member
Thread Starter
Join Date: Jul 2011
Location: Billings, MT
Posts: 174
Likes: 0
Received 0 Likes
on
0 Posts
Car: 92 Firebird--02 Grand Prix GTP 2Dr
Engine: Poncho 400--3.8 Supercharged
Transmission: T56 6 Speed--4T65EHD
Axle/Gears: Open 10 bolt 3.42--Internal 2.93
Re: How do you remove the giant plug for the gauges.
02-06-2013, 06:15 PM
#4
Re: How do you remove the giant plug for the gauges.
The part just pulls out but may be stuck by the seakler. Do not uindo the snaps on thje side, that holds the other part together. The 2 plugs that go in on the front held by the bolt snap together
it looks like this
it looks like this
Thread
Thread Starter
Forum
Replies
Last Post
evilstuie
Exhaust
24
02-28-2016 03:33 PM