Electronics Need help wiring something up? Thinking of adding an electrical component to your car? Need help troubleshooting that wiring glitch?

No Power After First Start Up

Thread Tools
 
Search this Thread
 
Old 07-06-2009, 12:14 PM
  #1  
Senior Member
Thread Starter
 
86firebirdta's Avatar
 
Join Date: Jul 2007
Location: Manteca, Ca
Posts: 582
Likes: 0
Received 0 Likes on 0 Posts
Car: 1983, 1986, 2001 Trans Am
Engine: 305 cfi, 350 carb, LS1
Transmission: 700,Edge 2800 th350,Edge 3400 4L60E
Axle/Gears: 9 Bolt 3.27 Borg-Warner, built 3.73
No Power After First Start Up

I have a 1986 trans am 305 tpi been sittin for 5 months while i did a lil bit of tune up stuff for it and when i just get about to start it it only started to crank for a second then nothin no accessories or anything looked in my fuse box and nothin popped ima get under and look for a short or anything but any suggestions would be a help
Old 07-06-2009, 12:28 PM
  #2  
Senior Member

 
89-bird's Avatar
 
Join Date: Mar 2009
Location: Pigeon Forge ,TN
Posts: 790
Likes: 0
Received 0 Likes on 0 Posts
Car: Firebird
Engine: 2.8 v/6
Transmission: t/5
Axle/Gears: open/3.42
Re: No Power After First Start Up

If it's sat for 5mths and not run I would charge the battery first and see if that does it cause a battery will discharge over time .
Old 07-06-2009, 12:42 PM
  #3  
Senior Member
Thread Starter
 
86firebirdta's Avatar
 
Join Date: Jul 2007
Location: Manteca, Ca
Posts: 582
Likes: 0
Received 0 Likes on 0 Posts
Car: 1983, 1986, 2001 Trans Am
Engine: 305 cfi, 350 carb, LS1
Transmission: 700,Edge 2800 th350,Edge 3400 4L60E
Axle/Gears: 9 Bolt 3.27 Borg-Warner, built 3.73
Re: No Power After First Start Up

fully charged up the night before
Old 07-06-2009, 12:45 PM
  #4  
Senior Member

 
89-bird's Avatar
 
Join Date: Mar 2009
Location: Pigeon Forge ,TN
Posts: 790
Likes: 0
Received 0 Likes on 0 Posts
Car: Firebird
Engine: 2.8 v/6
Transmission: t/5
Axle/Gears: open/3.42
Re: No Power After First Start Up

How are the connections at the battery and starter and the junction block ?
Old 07-06-2009, 12:51 PM
  #5  
Senior Member
Thread Starter
 
86firebirdta's Avatar
 
Join Date: Jul 2007
Location: Manteca, Ca
Posts: 582
Likes: 0
Received 0 Likes on 0 Posts
Car: 1983, 1986, 2001 Trans Am
Engine: 305 cfi, 350 carb, LS1
Transmission: 700,Edge 2800 th350,Edge 3400 4L60E
Axle/Gears: 9 Bolt 3.27 Borg-Warner, built 3.73
Re: No Power After First Start Up

they are all nice and tight is it could i have my starter hooked up wrong and blew a relay or fuse
Old 07-06-2009, 12:59 PM
  #6  
Senior Member

 
89-bird's Avatar
 
Join Date: Mar 2009
Location: Pigeon Forge ,TN
Posts: 790
Likes: 0
Received 0 Likes on 0 Posts
Car: Firebird
Engine: 2.8 v/6
Transmission: t/5
Axle/Gears: open/3.42
Re: No Power After First Start Up

Possibly , I would check to be safe .
Old 07-06-2009, 02:22 PM
  #7  
Senior Member
Thread Starter
 
86firebirdta's Avatar
 
Join Date: Jul 2007
Location: Manteca, Ca
Posts: 582
Likes: 0
Received 0 Likes on 0 Posts
Car: 1983, 1986, 2001 Trans Am
Engine: 305 cfi, 350 carb, LS1
Transmission: 700,Edge 2800 th350,Edge 3400 4L60E
Axle/Gears: 9 Bolt 3.27 Borg-Warner, built 3.73
Re: No Power After First Start Up

is there a certain order that goes on the bigger bolt and which color goes on the smaller one jus wanna make for sure i got it right
Old 07-06-2009, 02:29 PM
  #8  
Senior Member

 
89-bird's Avatar
 
Join Date: Mar 2009
Location: Pigeon Forge ,TN
Posts: 790
Likes: 0
Received 0 Likes on 0 Posts
Car: Firebird
Engine: 2.8 v/6
Transmission: t/5
Axle/Gears: open/3.42
Re: No Power After First Start Up

I believe it is purple for the small bolt on the solenoid and the others just go on the big bolt .
Old 07-06-2009, 03:18 PM
  #9  
Senior Member
Thread Starter
 
86firebirdta's Avatar
 
Join Date: Jul 2007
Location: Manteca, Ca
Posts: 582
Likes: 0
Received 0 Likes on 0 Posts
Car: 1983, 1986, 2001 Trans Am
Engine: 305 cfi, 350 carb, LS1
Transmission: 700,Edge 2800 th350,Edge 3400 4L60E
Axle/Gears: 9 Bolt 3.27 Borg-Warner, built 3.73
Re: No Power After First Start Up

there is no certain order that they go on
Old 07-07-2009, 12:02 AM
  #10  
Junior Member
 
Billy_Bob's Avatar
 
Join Date: Jul 2009
Location: Oregon
Posts: 68
Likes: 0
Received 0 Likes on 0 Posts
Car: 92 GMC Sierra 2500
Engine: 5.7l
Transmission: 4L70
Axle/Gears: GT4 3.73
Re: No Power After First Start Up

With a multimeter, test the battery voltage with the ignition on.

If the battery is good and you have a full charge, it should read 12 something volts with the ignition on. (Load on battery.)

Also you should be able to turn on your headlights and they should be bright without the engine running.

If you're not getting 12 volts with the ignition on and the headlights are dim when turned on, then there is a battery or other electrical problem.
Old 07-07-2009, 09:23 PM
  #11  
Senior Member
Thread Starter
 
86firebirdta's Avatar
 
Join Date: Jul 2007
Location: Manteca, Ca
Posts: 582
Likes: 0
Received 0 Likes on 0 Posts
Car: 1983, 1986, 2001 Trans Am
Engine: 305 cfi, 350 carb, LS1
Transmission: 700,Edge 2800 th350,Edge 3400 4L60E
Axle/Gears: 9 Bolt 3.27 Borg-Warner, built 3.73
Re: No Power After First Start Up

it aint the battery is there a fusable link that would break that would make it so that no power would go thro my car...jus a thought
Old 07-09-2009, 09:08 AM
  #12  
Senior Member

 
89-bird's Avatar
 
Join Date: Mar 2009
Location: Pigeon Forge ,TN
Posts: 790
Likes: 0
Received 0 Likes on 0 Posts
Car: Firebird
Engine: 2.8 v/6
Transmission: t/5
Axle/Gears: open/3.42
Re: No Power After First Start Up

There could be one comeing off the starter or one off your battery cable .
Old 07-09-2009, 05:36 PM
  #13  
Senior Member
Thread Starter
 
86firebirdta's Avatar
 
Join Date: Jul 2007
Location: Manteca, Ca
Posts: 582
Likes: 0
Received 0 Likes on 0 Posts
Car: 1983, 1986, 2001 Trans Am
Engine: 305 cfi, 350 carb, LS1
Transmission: 700,Edge 2800 th350,Edge 3400 4L60E
Axle/Gears: 9 Bolt 3.27 Borg-Warner, built 3.73
Re: No Power After First Start Up

on my wire diagram i have two that cos off my battery one goes to the ignition switch first then the second goes to the generator
Old 07-10-2009, 07:55 AM
  #14  
Senior Member

 
89-bird's Avatar
 
Join Date: Mar 2009
Location: Pigeon Forge ,TN
Posts: 790
Likes: 0
Received 0 Likes on 0 Posts
Car: Firebird
Engine: 2.8 v/6
Transmission: t/5
Axle/Gears: open/3.42
Re: No Power After First Start Up

Check those and see if there is anything wrong with them .
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Azrael91966669
DIY PROM
25
06-20-2017 04:04 AM
Orr89RocZ
Power Adders
206
04-25-2016 08:28 AM
86White_T/A305
LTX and LSX
0
08-17-2015 12:16 AM
mdtoren
Tech / General Engine
0
08-16-2015 05:45 PM



Quick Reply: No Power After First Start Up



All times are GMT -5. The time now is 04:53 PM.