MAF sensor/relay?
#1
MAF sensor/relay?
alright, so my problem is I'm pulling a code 33, MAF sensor. its on an 87 trans am 305 TPI. the odd thing is though, it usually runs fine...while the SES light is on. if I crank it up and the SES light doesn't come on, it usually comes on shortly down the road, no worries...runs fine. however if I crank it up and head out in a hurry, and the SES light doesn't come on, it will start bucking and shuddering around half throttle making it almost undrivable in any kind of traffic situation.
is there anyway I can bypass the MAF for the time being? I have a feeling its a bad relay but I need to wait till payday to get a new one
is there anyway I can bypass the MAF for the time being? I have a feeling its a bad relay but I need to wait till payday to get a new one
#2
Supreme Member
Join Date: Jul 2005
Location: North Central Mass.
Posts: 2,123
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1985 Berlinetta
Engine: Megasquirted TPI
Transmission: Transgo 700R4
Axle/Gears: 3.42
Re: MAF sensor/relay?
Unplug the MAF. That will force the car into limp home mode... It will at least drive.
#3
TGO Supporter
Join Date: Sep 2003
Location: conway, s.c.
Posts: 6,127
Likes: 0
Received 8 Likes
on
8 Posts
Car: 1989 Iroc-Z
Engine: 5.7L TPI
Transmission: 700R4
Re: MAF sensor/relay?
There is a new spray cleaner designed for MAF sensors that is on the market now. I believe that it is marketed by CRC and it is carried at most Advance stores. It comes in a gray can.
#5
Senior Member
Join Date: Jun 2007
Location: Clearwater, FL
Posts: 251
Likes: 0
Received 0 Likes
on
0 Posts
Car: 92 Camaro RS
Engine: 305
Transmission: Auto
Axle/Gears: Stock
Re: MAF sensor/relay?
has anyone seen much actual results with the MAF cleaner?
Most posts I ahve read on here, and back on my old BMW forum all said "tried cleaner, no change"....?
Most posts I ahve read on here, and back on my old BMW forum all said "tried cleaner, no change"....?
#6
Re: MAF sensor/relay?
ok, new development. turns out the previous owner replaced a bunch of wires with orange wire. I can't get to where they are spliced but I know that the three relays on the driver side of the firewall don't have their original colors. I'm also pulling a code 33 and 34. trying to make sure its not a wiring problem with the MAF before I have to go buy a whole new sensor. any ideas? again its on an 87 trans am, 305 TPI
#7
Supreme Member
iTrader: (2)
Join Date: Nov 2006
Location: Connecticut
Posts: 1,698
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1987 Camaro, 1986 Trans AM
Engine: V6 2.8 multi-port and V8 5.0 FI
Transmission: 5-Speed and Automatic
Axle/Gears: no idea
Re: MAF sensor/relay?
ever find out what the problem was? i have the same issue now
Thread
Thread Starter
Forum
Replies
Last Post
BumpaD82
Tech / General Engine
37
02-26-2016 02:57 PM