ECM Dump Moates Software
01-18-2002, 03:15 PM
#1
Member
Thread Starter
iTrader: (1)
Join Date: Jul 1999
Location: Chesterland, Oh
Posts: 182
Likes: 0
Received 3 Likes
on
3 Posts
Car: 92 Trans Am
Engine: 350 tpi
Transmission: 5 Speed
Axle/Gears: 3.42
ECM Dump Moates Software
What hex values should I use when using the dump function in Craig Moates sofware? I have a 730 ecm. I've tried a few numbers including 0 - 32767. The default values only get a 18k file and I think I'm supposed to get a 32K file.
After getting this file it should be able to be read from winbin, right?
After getting this file it should be able to be read from winbin, right?
01-18-2002, 09:12 PM
#2
Supreme Member
Join Date: Jul 1999
Location: Baton Rouge, LA, USA
Posts: 1,577
Likes: 0
Received 0 Likes
on
0 Posts
Car: 87 T/A
Engine: 441 SBC 12.5:1 0.680" Lift
Transmission: T-56
Axle/Gears: 4.10 TruTrac Moser 9"
Should go straight to Winbin without a problem.
The memory range for the 165 ought to be hex C000-FFFF (49152 to 65535 or 16x1024). For The 730 it should be 8000-FFFF (32768-65535 or 32x1024).
Hope this helps. If anyone knows different, let me know. Tell us how it turns out.
The memory range for the 165 ought to be hex C000-FFFF (49152 to 65535 or 16x1024). For The 730 it should be 8000-FFFF (32768-65535 or 32x1024).
Hope this helps. If anyone knows different, let me know. Tell us how it turns out.
Thread
Thread Starter
Forum
Replies
Last Post
efiguy
Engine/Drivetrain/Suspension Parts for Sale
0
09-27-2015 01:30 PM
