$OD MAF MPFI Specific Bin Beta realese
02-21-2011, 09:04 PM
#151
Supreme Member
iTrader: (2)
Join Date: Jan 2002
Location: Moorestown, NJ
Posts: 9,962
Likes: 0
Received 3 Likes
on
3 Posts
Car: 88 Camaro SC
Engine: SFI'd 350
Transmission: TKO 500
Axle/Gears: 9-bolt w/ 3.23's
Re: $OD MAF MPFI Specific Bin Beta realese
Too much accel enrich, probably MAP. It could be too much MAP volume. The AE values are from my car with a victor-e single plane, so it likely need a lot more than your intake. Once the engine is warm, there is no MAP AE, as its not needed. Try reducing the fuel mass in the MAP AE table. If that doesnt work, IOW, the AE is good at lower temps, but then the engine stumbles briefly for a period of time as the engine warms up, then its the cool temp mult that needs to be changed.
01-31-2012, 08:47 PM
#152
Junior Member
Join Date: Sep 2002
Posts: 93
Likes: 0
Received 0 Likes
on
0 Posts
Car: 91 Camaro
Engine: 383
Transmission: 700r4
Re: $OD MAF MPFI Specific Bin Beta realese
sorry to bring up an old thread but I was wondering if this is confirmed to be working good or not. I am considering going this route.
01-31-2012, 08:57 PM
#153
Junior Member
Thread Starter
Join Date: Nov 2009
Posts: 34
Likes: 0
Received 0 Likes
on
0 Posts
Re: $OD MAF MPFI Specific Bin Beta realese
I haven't had a chance to try the new changes, I am running the original still but with that said for me it was working great for me. Also I have not had much opportunity lately to mess with it so take that into consideration. All in all I thought it was pretty damn good. Hopefully you get some of these other guys to reply to get a good broad opinion. Good luck whatever you decide to do.
02-01-2012, 06:45 PM
#154
Member
iTrader: (1)
Join Date: Mar 2007
Location: Windsor , Ontario
Posts: 143
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1995 Chevy 4x4
Engine: 355 cu. in. Vortec / TPI / MAF
Transmission: 4L60E
Axle/Gears: 3.73 Limited Slip
Re: $OD MAF MPFI Specific Bin Beta realese
Adam did a great job on the $OD Maf Beta release once i got the bugs worked out on my end it went pretty smooth very happy with the out come . 
Thread
Thread Starter
Forum
Replies
Last Post
Vintageracer
Interior Parts for Sale
12
09-24-2017 12:34 PM
