is there anyone who can test ecm's and prom's?
#1
Member
Thread Starter
Join Date: Nov 2011
Posts: 112
Likes: 0
Received 0 Likes
on
0 Posts
Car: 89 trans am GTA
Engine: 355
Transmission: T56
Axle/Gears: 3.27
is there anyone who can test ecm's and prom's?
my mil is not doing the initial handshake blink when i first turn the key on. iac counts are stuck at 160 o2 reads pig rich no matter what (plugged in or not). blm's stay at 128 yet it smells rich an goes through 2 gals in 5 miles.
replaced every sensor brand new motor. checked all grounds even added a few.
im at wits end with this car.
replaced every sensor brand new motor. checked all grounds even added a few.
im at wits end with this car.
#3
Re: is there anyone who can test ecm's and prom's?
Check the inputs to the ECM first before replacing it.
Based on your username I assume you have a 92 which would be a 7730 ECM.
http://chevythunder.com/fuel%20injec...20(ecm#1227730)
Based on your username I assume you have a 92 which would be a 7730 ECM.
http://chevythunder.com/fuel%20injec...20(ecm#1227730)
#4
Re: is there anyone who can test ecm's and prom's?
BLMs might stay at 128 if open loop. Have you checked your plugs? Do they all look rich, or just a few? Are you going into closed loop? It sounds like you are scanning it; does everything look good?
Thread
Thread Starter
Forum
Replies
Last Post