removing side wing
01-08-2009, 08:58 PM
#1
TGO Supporter
Thread Starter
iTrader: (12)
Join Date: Jun 2002
Location: AR
Posts: 6,819
Likes: 0
Received 2 Likes
on
2 Posts
Car: 1991 Camaro RS Vert
Engine: 350 S-TPI
Transmission: T5
Axle/Gears: GU5/G80/J65
removing side wing
I've started my rust repair on my car. I am needing to remove the side wing so I can replace the quarter panel. I am wondering what is the best way to remove it? IIRC they are just double sided tapped down? So I should beable to take a knife and keep cutting between it and the fender?
Any pics of what the fender looks like after its removed?
Any pics of what the fender looks like after its removed?
01-09-2009, 09:41 PM
#2
Member
iTrader: (1)
Join Date: Nov 2007
Location: Surrey, BC, Canada
Posts: 312
Likes: 0
Received 4 Likes
on
2 Posts
Car: 1991 Z28 Convertible
Engine: 305 TPI
Transmission: 5-speed
Axle/Gears: 10 bolt, 3.08
Re: removing side wing
if you are not concerned about scratching a putty knife should work. I'd use fishing line myself.
01-11-2009, 08:10 AM
#3
TGO Supporter
Thread Starter
iTrader: (12)
Join Date: Jun 2002
Location: AR
Posts: 6,819
Likes: 0
Received 2 Likes
on
2 Posts
Car: 1991 Camaro RS Vert
Engine: 350 S-TPI
Transmission: T5
Axle/Gears: GU5/G80/J65
Re: removing side wing
I got it off yesterday with a utility knife.
Was not worried about scractching paint.
Was not worried about scractching paint.
Thread
Thread Starter
Forum
Replies
Last Post
1992 Trans Am
Exterior Parts for Sale
5
04-04-2016 12:50 PM