Can't figure out where this spring goes :(
06-01-2011, 07:05 PM
#1
Junior Member
Thread Starter
iTrader: (1)
Join Date: Nov 2009
Posts: 45
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1986 Camaro Z28
Engine: 305 4bbl
Can't figure out where this spring goes :(
E4ME. That's a dime next to it, to show the size of the spring. It's the only spring I have left for the rebuild and I don't see it on the parts diagram that came with the kit
06-01-2011, 08:38 PM
#3
Junior Member
Join Date: Jun 2011
Location: Dwight, Nebraska
Posts: 16
Likes: 0
Received 2 Likes
on
1 Post
Car: 1985 IROC Z-28
Engine: 5.7L 350
Transmission: 700R4
Axle/Gears: 3:83
Re: Can't figure out where this spring goes :(
if thats a dime that its next to then it would seem to be way to small and "tight" looking to be a fuel filter spring, i would look at your idle control screws everywhere... thats what it looks like to me anyway
06-01-2011, 09:14 PM
#4
Junior Member
Join Date: Oct 2010
Location: yonkers ny
Posts: 51
Likes: 0
Received 0 Likes
on
0 Posts
Car: 84 T/A Recaro
Engine: L69 H.o
Re: Can't figure out where this spring goes :(
Oo yeah you are probably right. when i think about it, it does looks like it.
06-02-2011, 01:25 PM
#6
Moderator
iTrader: (14)
Join Date: Mar 2000
Location: Littleton, CO USA
Posts: 43,169
Likes: 0
Received 35 Likes
on
34 Posts
Car: 82 Berlinetta/57 Bel Air
Engine: LS1/LQ4
Transmission: 4L60E/4L80E
Axle/Gears: 12B-3.73/9"-3.89
Re: Can't figure out where this spring goes :(
There should be two #421 springs, one for each idle mixture screw.
I'd tend toward #211, the TPS spring.
I'd tend toward #211, the TPS spring.
Thread
Thread Starter
Forum
Replies
Last Post
