4th gen w/Wall (4 Orion HCCA 15's), 70 pics
#1
Member
Thread Starter
Join Date: Feb 2002
Location: Phoenix, AZ
Posts: 101
Likes: 0
Received 0 Likes
on
0 Posts
4th gen w/Wall (4 Orion HCCA 15's), 70 pics
got pics of the camaro i'm building for all of you who wanted pics of a wall in a camaro, this is around a $12,000 install, after it's done, complete with kenwood indash DVD touchscreen, still working on it though, but tell me what you think.
It under the install section of my page
http://www.soundsolutionsaudio.com/installs.html
It under the install section of my page
http://www.soundsolutionsaudio.com/installs.html
#2
Supreme Member
Join Date: Aug 1999
Location: Lowell, MA
Posts: 1,437
Likes: 0
Received 0 Likes
on
0 Posts
Car: 89 Camaro RS
Engine: sbc 400
Transmission: th350
hey, not bad. just a question. you seem to have not skimped on anything in the install, but why particle board? mdf isnt that much more (if at all) and a bit more flex resistant, which is key for spl. thanks, and lets see some more when its done!
#3
Member
Thread Starter
Join Date: Feb 2002
Location: Phoenix, AZ
Posts: 101
Likes: 0
Received 0 Likes
on
0 Posts
went with Novaply
I went with nova ply, because: The front face is two 3/4" pressurized and glued together for the strength, read somewhere, that MDF, might not glue all that good together...didn't want to chance it, and as far as this flex, trust me this thing is very very sturdy! Thanks for the comments...
Thread
Thread Starter
Forum
Replies
Last Post