KFK

Hey guys I have come across something that I need to gather some cash for so the need to sell one of my babies. It is a clean rust free, 30k mile 1991 Z28. It currently has a nearly new ZZ4 crate motor (3k miles), at the same time a new clutch, and fresh world class spec t-5. the car has t-tops and is fully optioned. It was an auto car but is now manual, both sets of pedals will be included. It has upgraded lca and panhard bar but don't know the brand. The car has a SX fuel system and sumped tank(pump enough for big hp efi but regulated down for carb) The original 10 bolt has 3.73 gears and aluminum drums. The car has a cage, drive shaft loop, and shorty headers. This 30000 mile Z is CLEAN! No accidents but did have a factory recall paint job and no paint work since with the exception of when the cowl hood was installed 2 years ago the fender tops were blended. Asking $7000 obo The car is dusty in the pics I recently moved My cell is best bet 847 456 4804 Thanks
Ken

http://i303.photobucket.com/albums/n...1991Z28007.jpg

http://i303.photobucket.com/albums/n...1991Z28012.jpg

http://i303.photobucket.com/albums/n...91Z28010-1.jpg

http://i303.photobucket.com/albums/n...1991Z28004.jpg

http://i303.photobucket.com/albums/n...1991Z28002.jpg

ohiothirdgen

is the cage weld in or bolt in?

92lt1

sweet car! what kind and size is that cowl?

KFK

Sorry I have never measured the cowl and I dont know the brand. I owned the car before sold it to a friend then 2 yrs later bought it back and has sat since. When he owned it he installed the drive line and the hood (sold off the perfect original z hood - I almost killed him!)

The cage is welded in but no interior parts are cut and I would be willing to remove it if the buyer doesn't want it.

Also the car has sub-frame connectors.

KFK

I'm willing to sell as a roller also

convertking

How much for the body as just a roller? I have a 92 z-28 that has low miles that I hit a deer with, so I would probably use my complete drivetrain.

blue91z28cam

iTrader: (4)

do the t-tops leak at all?

eddies26

any interest in it as a roller as stated before ??
I have a built lt1 that would work well in here?
Also where are you located?
email to esymonds1@gmail.com
thanks
eddie