1le hubs and studs
03-18-2014, 10:48 AM
#1
Supreme Member
Thread Starter
iTrader: (1)
Join Date: Feb 2003
Location: check under the car
Posts: 1,143
Likes: 0
Received 4 Likes
on
3 Posts
Car: White 25th Anniversary RS
Engine: lt1
Transmission: t56
Axle/Gears: 4:10
1le hubs and studs
I am going to make a set of hubs and was wondering where I can get a set of extended studs needed to install my c4 rotors ?
Also does anyone know the exact diameter needed for 1le hubs?
Thanks!
Also does anyone know the exact diameter needed for 1le hubs?
Thanks!
03-18-2014, 12:05 PM
#2
Moderator
iTrader: (1)
Join Date: Mar 2002
Location: Chasing Electrons
Posts: 18,405
Likes: 0
Received 216 Likes
on
202 Posts
Car: check
Engine: check
Transmission: check
Re: 1le hubs and studs
If they have the same knurl as the non-1LE hubs these are what I used:
Studs: 10 pcs, napa 6411581 cross reference to dorman 610-323
54mm long, 0.509 knurl with an 8mm shoulder.
RBob.
Studs: 10 pcs, napa 6411581 cross reference to dorman 610-323
54mm long, 0.509 knurl with an 8mm shoulder.
RBob.
03-18-2014, 03:34 PM
#3
Supreme Member
Thread Starter
iTrader: (1)
Join Date: Feb 2003
Location: check under the car
Posts: 1,143
Likes: 0
Received 4 Likes
on
3 Posts
Car: White 25th Anniversary RS
Engine: lt1
Transmission: t56
Axle/Gears: 4:10
Re: 1le hubs and studs
Thanks. That helps alot. I have found also that the diameter of the machined 1le hub needs to be 5.9-6 inches for a brake upgrade.
Thanks again.
Thanks again.
03-19-2014, 07:51 AM
#4
Moderator
iTrader: (1)
Join Date: Mar 2002
Location: Chasing Electrons
Posts: 18,405
Likes: 0
Received 216 Likes
on
202 Posts
Car: check
Engine: check
Transmission: check
Re: 1le hubs and studs
I misunderstood your second question. For the final fitment of the rotor to the hub, the outer corner of the hub gets a decent sized chamfer on it. This allows it to clear the inside of the rotor without turning to whole OD of the hub down.
Once you start to dry fit the rotor and hub, why this is done will be apparent.
RBob.
Once you start to dry fit the rotor and hub, why this is done will be apparent.
RBob.
Thread
Thread Starter
Forum
Replies
Last Post
New2Chevy
Engine/Drivetrain/Suspension Parts for Sale
2
09-28-2015 12:35 AM
355tpipickup
Tech / General Engine
9
09-13-2015 11:35 PM
