PBR caliper position?
02-10-2013, 11:20 AM
#1
Supreme Member
Thread Starter
iTrader: (1)
Join Date: Sep 2010
Location: Georgetown TX
Posts: 1,928
Likes: 0
Received 0 Likes
on
0 Posts
Car: Base 91 'bird
Engine: 3.1 v6
Transmission: 4L60
Axle/Gears: 9-bolt 3.27 & PBR
PBR caliper position?
I'm putting PBR disk brakes on a 9-bolt from an '86 TA. The pictures I've seen show the calipers behind and low on the axle. However, when I try that the bleed screw is below the banjo bolt. The parts are all marked L and R so the only way it looks like they should go on is in front of the axle and above the center line. Is this right? Did PBR brakes get put in different positions?
02-10-2013, 12:46 PM
#2
Supreme Member
Thread Starter
iTrader: (1)
Join Date: Sep 2010
Location: Georgetown TX
Posts: 1,928
Likes: 0
Received 0 Likes
on
0 Posts
Car: Base 91 'bird
Engine: 3.1 v6
Transmission: 4L60
Axle/Gears: 9-bolt 3.27 & PBR
Re: PBR caliper position?
Unless the R goes on the driver side and L on the passenger???
02-10-2013, 12:57 PM
#3
Re: PBR caliper position?
No. Both to the back side. Pics in the following link might be helpful:
https://www.thirdgen.org/forums/faq-...iscs-89-a.html
JamesC
https://www.thirdgen.org/forums/faq-...iscs-89-a.html
JamesC
02-10-2013, 01:18 PM
#4
Supreme Member
Thread Starter
iTrader: (1)
Join Date: Sep 2010
Location: Georgetown TX
Posts: 1,928
Likes: 0
Received 0 Likes
on
0 Posts
Car: Base 91 'bird
Engine: 3.1 v6
Transmission: 4L60
Axle/Gears: 9-bolt 3.27 & PBR
Re: PBR caliper position?
So for that to work the parts stamped "R" need to go n the driver's side. I assumed at first they would go on the passenger side. Thanks.
Thread
Thread Starter
Forum
Replies
Last Post
the_hamturdler
Engine/Drivetrain/Suspension Parts for Sale
0
09-30-2015 12:50 PM
