1987 GTA Aerowing hardware
#1
1987 GTA Aerowing hardware
Is there hardware available to install an after market fiberglass aerowing? I was thinking using heilcoils to hold piece of metal to hold that would slide into the mount that is around the windshield.
#2
Supreme Member
iTrader: (12)
Re: 1987 GTA Aerowing hardware
In the pockets where the mounts would go run a screw into the middle of that pocket and then slide the wing into the slots, if it look like it needs to be brought closer to the glass, carefully remove the wing and run the screws in a bit more. Did mine like this and it worked fantastically.
#4
Supreme Member
iTrader: (5)
Join Date: Oct 2002
Location: In the paint booth!
Posts: 2,659
Received 1,161 Likes
on
654 Posts
Car: 1986 Camaro Drag Car
Engine: 383 on Ethanol
Transmission: Automatic
Axle/Gears: 3.90 Currie 9 inch
Re: 1987 GTA Aerowing hardware
I used screws on my brother's GTA wing when I put a fiberglass one on it. It worked just fine. 3 years later, it's still perfect.
#5
Junior Member
Join Date: Mar 2010
Location: Lake Country, BC
Posts: 5
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1987 IZ, 1990 IZ, 1992 GTA
Engine: 350 TPI
Transmission: 700R4
Thread
Thread Starter
Forum
Replies
Last Post