Turn signal mod question
04-29-2018, 08:11 PM
#1
Supreme Member
Thread Starter
Turn signal mod question
So I am replacing my running light in front with LED strips and the turn signal as well. So wired them up. Two strips to the red wire on the turn signal lead, and to the black. Wired two more to yellow lead and black. The two strips wired to red and black come on when headlights or running lights are on as intended. The other two strips wired to yellow and black which are supposed to be turn signals come on when the turn signal is switched on but DO NOT BLINK!
So what do yall think? Do I have my wiring wrong? Or do need to add a resistor to the blink circuit? Or is my resistance too high? Ideas anybody?
LEDs are 12 volt auto motive use BTW
So what do yall think? Do I have my wiring wrong? Or do need to add a resistor to the blink circuit? Or is my resistance too high? Ideas anybody?
LEDs are 12 volt auto motive use BTW
04-29-2018, 08:20 PM
#2
Member
Join Date: Jan 2017
Location: GA
Posts: 124
Likes: 0
Received 2 Likes
on
2 Posts
Car: 1991 rs, 1985 z28
Engine: 3.1 v6, 305 tpi
Transmission: 700r4, 700r4
Axle/Gears: 3.23, 3.23
Re: Turn signal mod question
If I recall correctly I heard something about having to maybe change the flasher to a different type
04-29-2018, 08:49 PM
#3
Supreme Member
Thread Starter
Re: Turn signal mod question
Possible I suppose maybe the ground also however I wonder because I do sometime have blink issues with the bulb with the head lights on.
Last edited by mmadden55; 04-29-2018 at 08:57 PM.
Thread
Thread Starter
Forum
Replies
Last Post
Firebat
Engine/Drivetrain/Suspension Wanted
2
04-25-2008 11:03 AM