Ground effects mount
#1
Supreme Member
Thread Starter
iTrader: (11)
Join Date: Aug 2005
Location: Chicago(DP)
Posts: 1,170
Likes: 0
Received 0 Likes
on
0 Posts
Car: '90 RS
Engine: Vortec 350
Transmission: 700R4
Axle/Gears: 3.23 non posi
Ground effects mount
Im putting my ground effects back on the car. But Im running into a problem on the peice that goe son the bottom of each door. I have the self thread cutting nuts for the middle three bolts but I dont know what to use fro the smalled bolts on each end. Went to a junkyard and noiticed theres some wierd nuts on the ends which you cant take off. Went to autozone and bought a variety of sizes for the thread cutting nuts and none of them fit! Any suggestions as to how I can tighten down the ends. Heres a pic of what bolt im talking about
#3
Supreme Member
Thread Starter
iTrader: (11)
Join Date: Aug 2005
Location: Chicago(DP)
Posts: 1,170
Likes: 0
Received 0 Likes
on
0 Posts
Car: '90 RS
Engine: Vortec 350
Transmission: 700R4
Axle/Gears: 3.23 non posi
Re: Ground effects mount
Cool that worked. Knocked out the studs and ran a course bolt through the rear hole and then put a bolt and nut through the front hoel since theres room to slide a nut behind it. Thanks
Thread
Thread Starter
Forum
Replies
Last Post
3rdgenparts
Exterior Parts for Sale
26
04-07-2016 11:21 AM
Thomas
Southern California Area
9
10-03-2015 05:31 PM
92firebirdchris
Exterior Parts for Sale
0
08-14-2015 11:56 AM