MAP Sensor Mounting Location with HSR
#1
Senior Member
Thread Starter
Join Date: Jul 2006
Location: 4-22 / 7-25
Posts: 811
Likes: 0
Received 2 Likes
on
2 Posts
Car: '91 Z28 L98 G92
Engine: Modded L98
Transmission: Modded 700R4
Axle/Gears: Modded 10-Bolt
MAP Sensor Mounting Location with HSR
For people with Speed Density TPI, where did you locate / mount the MAP sensor when you converted to HSR? Thanks in advance.
Bill
Bill
#3
Supreme Member
iTrader: (20)
Re: MAP Sensor Mounting Location with HSR
yep you can drill and tap a hole in the plenum somewhere. LT1 intakes have a hole in the top of the manifold, so you can copy that idea on the HSR
put it on the passenger side rear of the HSR plenum like factory TPI does it
There is a hole tapped under the plenum that could be used as well. Think its 1/8 NPT tapped, as i use it for my PCV valve vacuum setup. IF you run breathers or w/e, you probly could use that as a map sensor location as well.
either way you can get creative
put it on the passenger side rear of the HSR plenum like factory TPI does it
There is a hole tapped under the plenum that could be used as well. Think its 1/8 NPT tapped, as i use it for my PCV valve vacuum setup. IF you run breathers or w/e, you probly could use that as a map sensor location as well.
either way you can get creative
#4
Senior Member
Thread Starter
Join Date: Jul 2006
Location: 4-22 / 7-25
Posts: 811
Likes: 0
Received 2 Likes
on
2 Posts
Car: '91 Z28 L98 G92
Engine: Modded L98
Transmission: Modded 700R4
Axle/Gears: Modded 10-Bolt
Re: MAP Sensor Mounting Location with HSR
OK, thanks for the replies. Anyone else?
Bill
Bill
Thread
Thread Starter
Forum
Replies
Last Post
9192camaro
Engine/Drivetrain/Suspension Parts for Sale
16
02-03-2019 12:21 AM