classic industries door hinge kit?
08-15-2013, 11:31 PM
#1
Junior Member
Thread Starter
Join Date: Sep 2012
Location: OK
Posts: 57
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1989 camaro iroc-z
Engine: L98 350 5.7 bored 0.30 over
Transmission: 2400 stall lockout
Axle/Gears: 3.27
classic industries door hinge kit?
just wondering if anyone has used the door hinge kit they offer, which they say you will not have to cut the pin out or align the door?
http://www.classicindustries.com/198...ts/z28102.html
thanks guys.....
http://www.classicindustries.com/198...ts/z28102.html
thanks guys.....
08-16-2013, 03:40 PM
#2
Supreme Member
iTrader: (4)
Join Date: Mar 2009
Location: Pepperell, MA
Posts: 3,079
Likes: 0
Received 3 Likes
on
3 Posts
Car: 1987 Trans Am
Engine: LQ9/L92
Transmission: 4L60E
Re: classic industries door hinge kit?
They mention you don't have to cut out the hinge; all of these repair kits require you cut out the upper hinge "pins". Unfortunately there's no other way
08-16-2013, 07:24 PM
#3
Supreme Member
Join Date: Apr 2006
Location: Northern, CA
Posts: 4,482
Likes: 0
Received 8 Likes
on
8 Posts
Car: 1989 Iroc-Z Camaro
Engine: TBI,5.0
Transmission: Automatic 700R4
Axle/Gears: Eaton Posi,3.42,LPW Ultimate Cover
Re: classic industries door hinge kit?
I went with a Top Down Solutions Kit.
Take a look at this page then give Lon a call at the site and tell him what you want to do.
By the way you "WILL" need the door spring removal tool.
http://www.top-downsolutions.com/Bod...y-and-Interior
Take a look at this page then give Lon a call at the site and tell him what you want to do.
By the way you "WILL" need the door spring removal tool.
http://www.top-downsolutions.com/Bod...y-and-Interior
Thread
Thread Starter
Forum
Replies
Last Post
snowflake
Tech / General Engine
7
10-19-2015 10:24 PM
