Hurst Shifter
10-11-2000, 10:58 AM
#1
Member
Thread Starter
iTrader: (1)
Join Date: Jul 1999
Location: Chesterland, Oh
Posts: 182
Likes: 0
Received 3 Likes
on
3 Posts
Car: 92 Trans Am
Engine: 350 tpi
Transmission: 5 Speed
Axle/Gears: 3.42
Hurst Shifter
I just put in a Hurst Billet-plus shifter. I want to use leather **** from the stock shifter. Can this be done? The shifter shaft is 3/8" in diameter, while the **** is 5/8". Does anyone make an insert for this application? Hurst-Mr Gasket does not.
I did the Mcgyver modification to the the shifter.
I did the Mcgyver modification to the the shifter.
10-11-2000, 08:01 PM
#2
TGO Supporter
i was thinking the shifter was 7/16 or 1/2 but what ever it is any one with a lathe could make you a insert if the hole is bigger in the handle than the shifter shaft. if it's the other way make a plug for the **** and redrill and tap it. shouldn't be too hard to do.
------------------
-=ICON MOTORSPORTS=-
------------------
-=ICON MOTORSPORTS=-
10-12-2000, 01:43 PM
#3
10-17-2000, 07:27 PM
#5
Member
Join Date: Sep 1999
Location: Melbourne, FL
Posts: 265
Likes: 0
Received 0 Likes
on
0 Posts
Like my Hurst Billet Plus, but I ended up buying a B&M small leather **** and it was a perfect fit.
------------------
Mike
'90 IROC-Z, 5-speed, ZZ4, Trick Flows
Moderator SEThirdgen
------------------
Mike
'90 IROC-Z, 5-speed, ZZ4, Trick Flows
Moderator SEThirdgen
Thread
Thread Starter
Forum
Replies
Last Post